Simrad NX40 Installation Manual download pdf (Page 6)

4 | Preface

4.11 Connect the ground wire....................................................................... 34

5 Connect Simrad GB40 or Northstar 8000i .................................................. 35

5.1 Parts needed to connect radar to a GB40 or 8000i system........................... 35

5.2 Simrad GB40 using a SimNet heading sensor ............................................ 37

5.3 Northstar 8000i / Simrad GB 40 using a NMEA 0183 heading sensor............ 38

5.4 Radar system checklist........................................................................... 40

5.5 Setup the radar with the GB40 or 8000i.................................................... 40

6 Connect Simrad NX40 / NX45, Northstar M84 / M121 .............................. 43

6.1 Parts needed NX40/45 and M84/M121...................................................... 43

6.2 Simrad NX40/45 Northstar M84/M121 radar connections ............................ 44

6.3 Set up the radar with the Simrad NX40/45 or Northstar M84/M121 .............. 46

7 Connect Northstar 6000i / 6100i ............................................................... 47

7.1 Parts needed to connect to a Northstar 6000i / 6100i ................................. 47

7.2 Connect the radar processor to a 6000i or 6100i display ............................. 48

7.3 Connect the radar communications cable (NS003107) to the junction box ..... 49

7.4 Configure the remote power control for a 6000i or 6100i (common power

source) ............................................................................................... 51

7.5 Configure the remote power control for a 6000i or 6100i (different power

sources).............................................................................................. 52

7.6 Set up the radar with the Northstar 6000i or 6100i .................................... 54

7.7 Turn the radar on and off ....................................................................... 54

7.8 Configure the navigator communications .................................................. 55

7.9 Adjust the appearance settings ............................................................... 55

7.10 Heading sensor requirements ................................................................ 56

7.11 Disable the heading sensor input ........................................................... 56

7.12 Calibrating the radar ............................................................................ 56

7.13 Prepare for calibration .......................................................................... 56

7.14 Tune the radar .................................................................................... 57

7.15 Set the STC Curve ............................................................................... 57

7.16 Set the trigger delay ............................................................................ 57

7.17 Set the heading calibration (heading sensor installed)............................... 58

7.18 Set the heading calibration (heading sensor not installed) ......................... 59

7.19 Restore all the factory settings .............................................................. 59

7.20 Restore the factory appearance settings ................................................. 59

7.21 Manual tuning procedure for the 6000i or 6100i system ............................ 60

8 Maintenance .............................................................................................. 61

8.1 General maintenance ............................................................................. 61

8.2 Scanner maintenance ............................................................................ 61

8.3 Other maintenance items ....................................................................... 61

1 2 3 4 5 6 7 8 9 10 11 ... 79 80

No comments

Simrad NX40 Installation Manual Page 6