Simrad AP28 Technical Information Page 81

  • Download
  • Add to my manuals
  • Print
  • Page
    / 124
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 80
Setup at installation | 79
Compass calibration
Before the compass calibration is started, make sure that
there is enough open water around the vessel to make a
full turn.
The calibration should be done in calm sea conditions and
with minimal wind to obtain good results. Use about 60-
90 seconds to make a full circle.
1. Highlight the Calibrate line in the dialog
2. Begin turning the boat to port or starboard
3. Press the MENU key to start the automatic compass
calibration
a. An information window will be
displayed when the calibration
procedure is running.
b. The digits below the bargraph will
read 0.0 when the turn rate is
correct. Too high or too low turn
rate is indicated as follows (For
RC42 Rate Compass only!):
Turn rate too high,
turning cw
Turn rate too low,
turning cw
4. The automatic calibration is completed when the
information window disappears from the display
Page view 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 123 124

Comments to this Manuals

No comments