Simrad TP22 Instruction Manual download pdf (Page 9)

Instruction Manual

E04818 Issue 1.0

2 OPERATION

2.1 General

The keypad of the Tillerpilot has been designed to be as simple

and intuitive to operate as possible. Using only five keys (see

Fig 2.1), it is possible to perform precise course adjustments

and navigational functions.

The unit powers up in Standby mode indicated by a flashing

LED next to the STBY/AUTO key (Fig 2.1). The two direction

LEDs above the Port ( ) and Starboard ( ) keys are always

dimly lit, which provides night illumination for the keypad. All

functions are confirmed audibly by a “beep” and visually by

the LEDs, so the status of the unit can always be confirmed at a

glance.

Note The NAV key on the TP22 and TP32 is labeled CAL on the

TP10. Both keys are referenced where applicable.

2.2 Autopilot mode

While in Standby mode, the pushrod can be manually driven in

and out by pressing the arrowed Port ( ) and Starboard ( )

keys, which allows “power steering” of the vessel.

To engage Autopilot mode, press the STBY/AUTO key and the

Tillerpilot will lock onto the current course. The LED next to

this key will stop flashing and remain permanently lit as long

as the pilot is in Autopilot mode (Fig 2.2).

To lock the pilot onto the desired course, either steer the correct

course and then engage the autopilot, or engage the autopilot

and then adjust the heading until the correct course is being

sailed (see section 2.3 below).

If the STBY/AUTO key is pressed and held, the pilot will beep

a second time and lock onto the previously used heading (this

feature will not be available if the unit has just been switched

on).

Fig 2.1 - Standby mode

STBY

NAV

TACK

STBY

AUTO

STBY

AUTO

Fig 2.2 - Engaging

Autopilot mode

STBY

NAV

TACK

STBY

AUTO

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Simrad TP22 Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Navigational compasses Simrad TP22