Simrad NSS7 Installation Manual Page 62
- Page / 96
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
60 |
StructureScan™ | NSS Operator Manual
Measuring distance
The cursor can be used to measure the distance between two observations on the
StructureScan image. It is easier to use the measure function when the sounder image is
paused.
1. Activate the menu to start the measure function
- The cursor will be positioned in the middle of the panel, and the distance will be measured
from this position
2. Tap on the screen to select the second measuring point
- A line will be drawn between the measuring points, and the distance will be listed in the
Information window
3. Continue tapping the screen to position new measuring points
When you press the Finish measuring panel button or the
X key the echosounder will
resume to normal scrolling.
Pausing StructureScan™
You can pause the StructureScan, allowing you to examine the structures and other images in
more depth and detail.
This function is useful when you need to position a waypoint exactly on the Structurescan
image, and if you are using the cursor to measure a distance between 2 elements on the
image.
Recording the StructureScan™ data
You can record StructureScan data and save the fi le internally in the NSS unit, or onto a Micro-
SD card as described in “Recording and viewing the echosounder data” on page 57.
Structure options
Structure palette
Several display palettes with varying degrees of color and brightness are available.
Structure noise rejection
Signal interference from bilge pumps, engine vibration and air bubbles can clutter the
StructureScan image.
The noise rejection option fi lters the signal interference and reduces the on-screen clutter.
Clarity
Wave action, boat wakes and temperature inversion can cause on-screen clutter near the
surface.
The clarity option reduces surface clutter by decreasing the sensitivity of the receiver near the
surface.
Flipping Left/Right image
If required, the left/right SideScanning images can be fl ipped to match the corresponding
side of you vessel.
The Structure source
If you have more than one StructureScan on your network, you can select which unit to be
the preferred source on this NSS unit.
- Operator Manual 1
- Copyright 3
- Warranty 3
- Declarations and conformance 3
- About this manual 3
- The software 4
- Contents 5
- 87 Menu and dialog overview 8
- 90 Index 8
- Introduction 9
- The NSS screen 10
- Pages overview 12
- Settings 12
- Basic operation 13
- The menus 14
- Dialog boxes 14
- Placing the cursor 15
- Charts 16
- Placing waypoints 17
- Creating routes 17
- Dragging waypoints 17
- Measuring distance 17
- Chart overlay 18
- Using 3D charts 18
- Vessel mode 19
- Explore mode 19
- Navionics chart options 20
- The chart settings panel 21
- 3D boat selection 22
- Synchronize 2D/3D chart 22
- Waypoints 23
- T r acks 24
- Creating a new track 25
- Track settings 25
- Navigating with the NSS 26
- Arrival radius 27
- O course (XTE) limit 27
- Arrival alarm 27
- Loran settings 28
- Data elds 29
- The course line 29
- Vessel symbol 29
- O course limit 29
- Data elds 29
- Using the autopilot 30
- Power steering (NFU) 33
- Follow-up steering (FU) 33
- AUTO mode (auto compass) 33
- Zigzag-turns 35
- Square-turn 35
- Lazy S-turn 35
- NoDrift mode 37
- Sailing with the autopilot 38
- Tacking in Auto mode 39
- Tacking in Wind mode 39
- Wind steering and navigation 40
- Auto-hide 41
- Crescent lights 41
- Chart compass 41
- Locking an NSS unit 41
- Sea state lter 41
- Tack time 42
- Tack angle 42
- Wind function 42
- VMG optimizing 42
- Layline steering 42
- Automatic steering 43
- Installation 43
- Transmit 44
- Optimizing the radar image 45
- Positioning the radar center 45
- T rue motion 46
- Using the cursor 46
- Range rings 46
- EBL/VRM 46
- Radar options 47
- Heading up 48
- North up 48
- Course up 48
- MARPA targets 49
- Target trails and safe rings 50
- The vessels extension lines 50
- Defi ning 50
- Radar settings panel 51
- Auto range 52
- Preset range levels 52
- Custom range 52
- Bottom lock 53
- Auto gain 54
- Pausing the echosounder 55
- Echo options 56
- StructureScan™ overlay 57
- Overlay downscan 58
- DownScan 59
- SideScan 60
- Zooming 60
- Adjusting the color settings 61
- Pausing StructureScan™ 62
- Structure options 62
- The Instruments panels 63
- Using AIS 64
- Radar pages 65
- Chart pages 65
- Filtering the targets 66
- Speed and course indication 66
- AIS icon orientation 66
- Enabling audio 67
- The audio media bar 67
- Operating the audio source 68
- Audio playback 69
- Using the FM/AM radio 69
- Using Sirius radio 70
- The weather display 71
- Weather symbology 72
- Weather alarms 73
- Weather reports 73
- Using Video 74
- Mirroring the video image 75
- The video standard 75
- BEP CZone 76
- The CZone info panel 77
- The alarm system 78
- Autopilot section 79
- The Tools page 80
- W aypoin ts/routes/tracks 81
- T rip Log 81
- Sun/moon 81
- Customizing your system 83
- Changing system settings 84
- GPS source 86
- Speed, Course and Route 86
- Set start position 86
- Maintenance 87
- Backing up your system data 88
- Menu and dialog overview 89
- Insight chart database 90
- Navionics chart database 90
- Index 92
- *988-10102-002* 96
Related products and manuals for Navigators Simrad NSS7
Navigators Simrad AC42 Technical Information
(116 pages)
(116 pages)
Navigators Simrad AP26 User Manual
(148 pages)
Navigators Simrad MX525A Specifications
(34 pages)
(34 pages)
Navigators Simrad RS12 VHF User's Guide
(72 pages)
(72 pages)
Navigators Simrad MX525A User Manual
(2 pages)
(2 pages)
Navigators Simrad MX525A User Manual
(2 pages)
(2 pages)
Navigators Simrad MX525A Specifications
(34 pages)
(34 pages)
Navigators Simrad AP50 Specifications
(62 pages)
(62 pages)
© 2020, manymanuals.com. All rights reserved. | 5.676 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals