Simrad NSS7 Installation Manual Page 74

  • Download
  • Add to my manuals
  • Print
  • Page
    / 96
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 73
72 |
Using Video | NSS Operator Manual
Using Video
The video function allows you to view videos or camera sources on your NSS screen.
For information about how to connect the camera, see the separate NSS Installation manuals
Note: The video images will not be shared via the network. You can only view the video on
the unit connected to the video source.
The video panel
The video image will be proportionally scaled to fi t into the video panel. Area not covered by
the image will be colored black.
The graphics below show images from a thermal imaging camera.
The video menus
When you tap the video panel, the video panel buttons are displayed. Tapping the screen
again makes these go away.
When the video panel buttons are active you can display the full video menu by:
MARK
MENU
Pressing the MENU key
Tapping the MENU panel
button
Pressing and holding on the
video panel
Setting up the video panel
The video source
NSS supports two video input channels. You can select to view one channel only, or to cycle
the image between available video cameras.
The cycle period can be set from 5 to 120 seconds.
Adjusting the video image
You can optimize the video display by adjusting the video image settings. The settings are
adjusted individually for each video source.
Default for all settings: 50%.
14
Page view 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 95 96

Comments to this Manuals

No comments