Simrad AP70 Installation Manual Page 12
- Page / 66
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
10 |
Basic operation | AP70/AP80 Operator Manual
Turning the autopilot system on/o
You turn ON the autopilot system on by a short press on the POWER key when this is red
light colored.
The system is turned OFF (Sleep mode) by pressing and holding the POWER key on an active
control unit. During the shut-down procedure the system will automatically go to Standby
mode before it is turned off . If the POWER key is released before shut-down is completed,
the power off is cancelled.
Note: The POWER key will remain lit on units that are turned OFF. Note: To stop the system
from drawing current a separate breaker should be installed.
The menus
You display a menu by pressing the MENU key.
• Use the rotary knob to select a menu item, then press the rotary knob or the STBD key to
confi rm your selection
• Toggle on/off a check box by pressing the rotary knob or the STBD key
• Activate a slide bar by pressing the rotary knob or the STBD key, then select the value by
turning the rotary knob. Confi rm your selection by pressing the rotary knob or the STBD key
• Expand a Drop-down listing by pressing the rotary knob or the STBD key, then select the
item by turning the rotary knob. Confi rm your selection by pressing the rotary knob or the
STBD key
• Press the PORT key to return to previous menu level. Repeat pressing the PORT key to exit
the menus.
Check box Slide bar Drop-down listing
Dialog boxes
You select entry fi elds and keys in a dialog box by using the rotary knob. You can only enter
information when a fi eld is selected and highlighted.
You exit a dialog and cancel your entries by selecting the Cancel key in the dialog, or by
pressing the PORT key.
You confi rm your entries and close the dialog by selecting the OK key in the dialog, or by
pressing the STBD key.
An alphanumeric keyboard will automatically be displayed when
required for entering user information in dialogs.
1. Select characters by turning the rotary knob
2. Confi rm your entry by pressing the rotary knob
3. Complete your entry by pressing the Enter key on the virtual
keyboard
Display illumination
Light adjustment
A single press on the POWER key will display the light adjustment dialog. The brightness
level is adjusted by the rotary knob.
Repeated presses on the POWER key will toggle between preset brightness levels (10 - 6 - 3-
1).
- AP70/AP80 1
- Disclaimer 3
- Compliance 3
- The Wheelmark 3
- Copyright 3
- Warranty 4
- About this manual 4
- Contents 5
- 42 Maintenance 6
- 44 Menu overview 6
- 47 System con guration 6
- Introduction 7
- The screen 8
- Operational mode overview 10
- Basic operation 11
- The menus 12
- Dialog boxes 12
- Display illumination 12
- Taking command 13
- Selecting autopilot modes 13
- Acknowledging a message 14
- Working with thrusters 14
- Selecting work pro les 14
- Thruster presentation 15
- Steering stations 16
- Open systems 16
- WING STATION 17
- AFT STATION 17
- MAIN BRIDGE 17
- De ning a Master system 18
- The operational modes 20
- Hand steering 21
- AUTO modes 22
- The Turn preset feature 23
- Using turn preset 24
- U-turn pattern steering 25
- Navigating mode 25
- The NAV mode info panel 26
- The waypoint arrival circle 26
- Turning in NAV mode 27
- The Quick menus 28
- Simulator mode 29
- W ork pro le setup 30
- Auto steering 31
- Track steering 32
- Drive select 32
- Thruster 33
- Edit a pro le 34
- The alarm system 36
- Acknowledging a message 37
- The alarm dialogs 37
- When no monitor compass 38
- Maintenance 44
- Software upgrades 45
- Backing up your system data 45
- File management 45
- Menu overview 46
- NoDrift and NAV mode 47
- Advanced system settings 48
- System con guration 49
- Auto select 50
- Manual source selection 50
- Group selection 50
- Advanced selection 50
- Device list 51
- Diagnostics 51
- AP80 CONTROL HEADNF80 52
- Master systems 53
- Installation settings 54
- Con guring the drive system 55
- Con guring the handshake 56
- Handshake settings 56
- Drive test/calibration 58
- Boat type 58
- Boat length 59
- Cruising speed 59
- Transition speed 59
- Thruster inhibit speed 59
- Low speed limit 60
- Init rudder 60
- Turn type and Turn value 61
- Track approach angle 61
- Autotuning 62
- Manual tuning 63
- *988-10198-002* 66
Related products and manuals for Navigational compasses Simrad AP70
(40 pages)© 2020, manymanuals.com. All rights reserved. | 0.668 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals