Simrad AP70 Installation Manual Page 39

  • Download
  • Add to my manuals
  • Print
  • Page
    / 80
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 38
| 37
System con guration | AP70/AP80 Operator Manual
System con guration
General
When the autopilot installation is completed, the system must be confi gured and the
commissioning procedures performed. Failure in setting up the autopilot correctly may
prohibit the autopilot from functioning properly.
The settings dialog and submenus
The system confi guration settings are logically grouped in the Settings dialog, and each
group is presented with an icon. This dialog is accessed by pressing the Settings icon available
in all mode specifi c menus, or by double clicking the MENU key.
Icon Description Refer
System settings. These settings have no aff ect
on autopilot performance
AP70/AP80 Operator
manual
Work profi le settings
Active alarms, alarm history and alarm
settings
Units of measure used on display, in dialogs
and menus.
-
Network sources setup
“Network settings” on page
38
Installation setup.
The pilot must be in Standby mode to access
these settings
“Installation settings” on
page 42
Turning on for the  rst time
Before attempting to turn on the autopilot and perform an Installation Set-up, the hardware
installation and electrical installation must be completed and performed in accordance with
the installation instructions
The fi rst time the autopilot system is started and after a factory reset, you will be guided
through a set of initial settings.
If the settings are not completed, you can confi gure the autopilot system manually as
described in the following sections.
4
Page view 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 79 80

Comments to this Manuals

No comments