Simrad NX45 Specifications download pdf (Page 69)

Simrad NX40/45 Installation and Operation Manual 69

17-4 SmartCraft setup summary

From the SETUP menu, select SmartCraft•

The setup options are as indicated below.

17-4-1 Troll window

Select from a menu:

On idle: Troll window is displayed; the throttle

is at idle and the engine is in gear.

Always: Troll window is displayed.

Never: Troll window is not displayed and not

available.

17-4-2 Troll mode

You can select what Troll mode controls:

RPM: Controls engine idle RPM

Speed: Controls engine idle RPM to try

to achieve the desired boat speed.

17-4-3 Trim popup

You can select:

Off: Trim popup window is never displayed.

On: Trim popup window is displayed when

trim is changed.

16-4-4 Trim popup lter

This lter can stop the trim popup window appearing

because of engine vibration rather than a trim change.

Select Off or a low value rst. Run the boat at a range

of speeds and increase the value if vibration causes the

trim popup window to appear. If the value is high, the

trim window will appear slowly when trim changes.

17-4-5 Speed type

You can select the source of the water (boat) speed

reading:

Pitot: The engine’s pitot sensor

Paddle: A paddlewheel sensor

The pitot sensor is more accurate at high speeds but not

at low speeds. The paddlewheel sensor is more accurate

at low speeds.

To use troll speed control:

Set speed type to • paddle.

17-4-6 Pitot type

You can either select 100 psi or 200 psi to match the

pitot type installed on the boat.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 119 120

No comments

Simrad NX45 Specifications Page 69