Simrad Autopilot AP26 User Manual download pdf (Page 45)

Installation

20221586B 43

Notes !

1. Simrad products will be identified by the product name

provided the data is available on SimNet. If data is

provided via an NMEA0183 port on the autopilot

computer, the display will read NMEA-1 or NMEA-2.

NMEA2000 products will have a special ID.

2. See note on page 74 and note 3 below.

3. In the event the SimNet is not powered on, sources

supplying data to SimNet are not on or malfunctioning, or

there is no SimNet installed, it is possible to use any

control unit in the system to select NMEA sources. The

source select displays are then available on all control

units.

Compass

Select the compass to be used if more than one

compass is connected.

Navigation

Select the source for navigational data.

Position

Select the source for position data.

Wind Angle

Select the source for Wind Angle.

Wind Calculated

Select the source for Calculated Wind data for the

Simrad group. AP uses internal sources irrespective

of the selected source.

Water Speed

Select the source for water speed (normally the same

as the source providing Log data).

Water temperature

Select the source for water temperature (normally the

same as the source providing depth data).

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 151 152

No comments

Simrad Autopilot AP26 User Manual Page 45