Simrad GC80 Instruction Manual download pdf (Page 27)

OPERATION

20221511 / C 19

3.7 Alarm messages

The GC80/GC85 system will continually check for faults while

the system is running.

If a fault occurs, an alarm code will be displayed in the LCD, the

Alarm lamp will be flashing, and an audible alarm will be

activated.

Up to 4 alarm codes may be displayed in the LCD to indicate

that several alarm situations are present. The last activated alarm

will be displayed on the right side of the display. The figure

shows that alarm with code 1, 3 and 2 were generated in that

order.

^i^oj

If more than 4 alarms are active, this will be indicated with a dot

behind the last number as shown on the figure below. Further

alarm codes may then be displayed by pressing the “arrow up”

button.

The example shows that alarm code 2, 3, U, d and 7 were

activated.

Caution When an alarm is generated, bearing information from the

GC80/GC85 may not be present or may have large error. Any

equipment using bearing information from the gyro compass

should therefore immediately be operated according to the

equipment’s emergency operating procedure.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 111 112

No comments

Simrad GC80 Instruction Manual Page 27