Simrad AP50 Installation Manual download pdf (Page 34)

Installation

20222469 / B 25

2.11 Control Unit

Avoid mounting the control unit(s) where it is easily exposed to

sunlight, as this will shorten the lifetime of the display. If this is

not possible, make sure the units are always covered with the

protective cover when not in use.

Panel-mounting

The mounting surface must be flat and even to within 0.5 mm.

• Drill the 4 mounting holes and

make a panel cutout according to

the supplied template.

• Use the supplied gasket between

the panel and the unit.

• Use the supplied 19 mm screws to

fasten the control unit to the panel.

• Apply the front panel corners.

• Connect the Robnet cable(s) to the

control unit connector(s) (see

“Note!” on page 28).

Gasket

Optional Bracket mounting

(This may be ordered separately from Simrad, part no.

20212130).

Note ! When the control unit is bracket-mounted, it is not weatherproof

from the back due to a breathing hole in the back cabinet. When

bracket-mounted, the exposed parts of the plugs should be

protected against salt corrosion.

• Locate the cradle on the mounting site and mark the 4 holes

for the screws on the mounting surface.

• Drill the 4 holes and screw the cradle to the mounting

surface.

• Use the supplied screws to fasten the control unit to the left

and right brackets.

• Apply the front panel corners.

• Use the two locking knobs to assemble the cradle with the

left and right brackets and adjust the control head for the best

viewing angle.

• Connect the Robnet cable(s) to the control unit connector(s)

(see “Note!” on page 28).

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 133 134

No comments

Simrad AP50 Installation Manual Page 34