Software Set-up Procedure
20222469 / B 47
• Exit the Installation Menu by pressing STBY, AUTO or
NAV buttons.
On new installations, and whenever a junction unit or software
is replaced in an AP50 system, it is recommended that a Master
Reset be performed as described under SERVICE in the
Installation Menu (see page 77) prior to proceeding with the set-
up procedure.
Note ! If a “System Select” switch is installed (page 18) it must be set
to the autopilot system, otherwise the rudder can not be
calibrated for direction and feedback signal in the Dockside
menu.
When using the Installation Menu refer to
Figure 3-1
"Installation Menu Flow Chart" on page
48.
Language selection
The AP50 can present the display in eight different languages:
• English, Deutsch, Francais, Español, Italiano, Nederlands,
Svenska and Norsk.
LANGUAGE
English
Deutsch
Francais
Espanol
Italiano
Nederlands
Svenska
Norsk
To access the language selection in the Installation Menu:
1. Answer “Yes” by turning the course knob clockwise.
2. Turn the course knob to select the language you wish to use.
3. Continue to next item in the Installation Menu by pressing the
(STBD) button or leave the Installation Menu by pressing
the
STBY
(STBY) button.
Dockside
The following menu items are accessible and can be set up in
the Dockside Set-up Menu:
• Master operation
• Boat type
• Boat length
• Drive unit voltage
• Rudder / Feedback calibration
• Rudder test
• Rudder limit
• Rudder deadband
• Thruster type
Select STANDBY mode and enter the Installation Menu as
previously described. Select "Dockside" by pressing
(STBD)
button and confirm by rotating the course knob clockwise.
Comments to this Manuals