Simrad AP50 Installation Manual Page 73
- Page / 134
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Simrad AP50 Autopilot
64 20222469 / B
Set Thrust Direction, On/Off Thruster
(ONLY IF ON/OFF THRUSTER IS SELECTED, proceed to
page 65 if continuous thruster or Danfoss thruster is selected)
No
Yes
SEATRIAL
Compass Flux1
Calibration
Offset +005°
Heading 288°
Set thrust direction
Speed source Man
Set cruising speed 15kt
P S
Adjust?
SEATRIAL
Set thrust direction
STBD
Rotate the course knob clockwise to activate the Set thrust
direction setting.
Rotate the course knob to starboard and verify that the vessel
turns to starboard. The thruster stops after 10 seconds, or when
the
(STBD) button is pressed.
If the boat turns to port when the course knob is turned to
starboard, rotate the knob to port to ensure a starboard turn.
This tells the autopilot which direction to turn the thruster.
For ON/OFF thrusters, a change in direction command will
always be delayed 1 second to prevent thruster breakage.
Note ! If advanced set-up of the thruster is required, refer to the
SETTINGS menu on page 86.
Proceed to the “Speed source” item on page 66 by pressing the
(STBD) button or return to STANDBY mode by pressing the
STBY
(STBY) button.
Thruster Calibration, Analog Thruster
SEATRIAL
Compass Flux1
Calibration
Offset +005°
Heading 288°
Thruster CAL
Speed source Man
Set cruising speed --kt
No
Yes
SEATRIAL
Thruster zero 00%
Maximum thrust STBD ---%
Maximum thrust PORT ---%
Minimum thrust 00%
(ONLY IF CONTINUOUS THRUSTER OR DANFOSS
THRUSTER IS SELECTED)
Rotate the course knob clockwise to select the Thruster CAL
display.
Thruster zero
Rotate the course knob until you have no output effect from the
thruster. The Thruster zero offset is now set.
Range: -50% to +50% in step of 1%.
Default: 0%.
Proceed to the Maximum thrust STBD item by pressing the
(STBD) button.
- Installation manual 1
- SIMRAD AP50 2
- About this document 3
- Installation Manual 4
- Contents 5
- 20222469 / B v 6
- 20222469 / B vii 8
- 1 GENERAL INFORMATION 10
- 1.2 How to Use This Manual 11
- 2 INSTALLATION 12
- 2.5 AP50 System Layout 14
- JUNCTION UNIT 16
- Max 600mm (23,5") 17
- Electrical Connection 18
- Mechanical Alignment 20
- Mechanical mounting 21
- Electrical installation 21
- 20222469 / B 13 22
- RF14XU ELECTRONIC MODULE 23
- 20222469 / B 15 24
- 2.9 J50 Junction Unit 25
- 20222469 / B 17 26
- Junction Unit Terminals 27
- System Select 27
- Toggling) 28
- 2.10 Drive Unit Installation 29
- Connecting a Reversible Pump 31
- 2.11 Control Unit 34
- HOW TO REMOVE PINS: 36
- Insert tool in slot 36
- Pull the wire 36
- Extraction tool 36
- FRONT VIEW 37
- JP21 Jack Point Installation 38
- 2.12 RC25 Rate Compass 39
- CONTROL 40
- RFC35 Fluxgate Compass 41
- 2.13 FU50 Steering Lever 42
- 2.14 TI51 Thruster Interface 42
- 2.15 AD50 Analog Drive 42
- 2.16 S9 Steering Lever 42
- Connection 43
- 20222469 / B 35 44
- POWER PCB 49
- Analog Heading Repeater 50
- Digital Heading Repeater 50
- GI51 Gyro Interface 50
- 20222469 / B 43 52
- CDI35 Interface 53
- 3 SOFTWARE SET-UP PROCEDURE 54
- 3.2 Installation Menu 55
- Language selection 56
- Dockside 56
- 48 20222469 / B 57
- 20222469 / B 49 58
- P S 59
- 20222469 / B 53 62
- Interface Set-up 63
- 20222469 / B 55 64
- 20222469 / B 57 66
- 58 20222469 / B 67
- Software Set-up Procedure 68
- 60 20222469 / B 69
- Sea Trial 70
- +000° 71
- 20222469 / B 63 72
- +005° 76
- 20222469 / B 69 78
- 20222469 / B 71 80
- 3.3 Final Test 81
- 3.4 Providing User Training 82
- 4 ADVANCED SETTINGS 84
- NMEA Data 85
- Master Reset 86
- 4.2 Settings Menu 87
- 20222469 / B 79 88
- Bypass/clutch: 89
- Handshake 1: 89
- 20222469 / B 81 90
- 20222469 / B 83 92
- 20222469 / B 85 94
- Thruster 95
- 20222469 / B 87 96
- SETTINGS 98
- 5 SPARE PARTS LIST 100
- 20222469 / B 101
- 20222469 / B 93 102
- 6 TECHNICAL SPECIFICATIONS 104
- 6.2 AP50 Control Unit 105
- 6.3 AP51 Remote Control 106
- 6.4 Junction Units 107
- 6.5 RC25 Rate Compass 108
- 6.7 CD100A Course Detector 110
- 6.8 CD109 Course Detector 110
- 20222469 / B 103 112
- 6.12 NI300X NMEA Interface 114
- 6.13 TI51 Thruster Interface 115
- 6.14 AD50 Analog Drive 115
- SIMRAD R3000X 116
- STBY AUTO 116
- 6.16 S9 Steering Lever 117
- 6.18 NMEA Sentences 118
- Remarks: 119
- 7 INDEX 120
- 20222469 / B 113 122
- Simrad AP50 Autopilot 123
- 114 20222469 / B 123
- Work Turn Gain, 85 123
- 8 APPROVALS 124
- 8.2 Certificates 125
- Simrad doc.no.519103/F 126
- Simrad doc.no.519107F 128
© 2020, manymanuals.com. All rights reserved. | 0.134 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals