Simrad AP50 Installation Manual download pdf (Page 35)

Simrad AP50 Autopilot

26 20222469 / B

Figure 2-20 AP50 Bracket mounting

Robnet Units and Robnet Network Cables

The following Robnet units are available in a system:

AP50 Control Unit, AP51 Remote Control, RC25 Rate

Compass, FU50 Follow-Up lever, GI51 Gyro Interface, NI300X

NMEA Interface, TI51 Thruster Interface and AD50 Analog

Drive.

As most Robnet units have two Robnet connectors, they can be

used for further expansion of the system. There are no dedicated

"in" or "out" connectors. You may connect the cables to any

available Robnet connector on the specific unit.

The Robnet cables are available in 7 and 15 m lengths and they

contain a 6-pin male connector at one or both ends. The 15 m

cable to the junction unit has a connector only at the control unit

end.

Additional extension cable (10 m) with a male and a female

connector, is available from Simrad (part no. 22192266).

When installing a system, try to minimize the total Robnet cable

length by connecting all Robnet units to the nearest available

Robnet connector.

The total length of Robnet cables depends on the number of

Robnet units and the voltage drop across the connected units.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 133 134

No comments

Simrad AP50 Installation Manual Page 35