Simrad AP50 Installation Manual download pdf (Page 42)

Installation

20222469 / B 33

RFC35

FLUXGATE

COMPASS

JUNCTION UNIT

MAIN PCB

Heading

Sensor

* NON POLARIZED

(COLOR INDEPENDENT)

HS+

HS-

Figure 2-28 RFC35 connection

• Change in the Installation Interface menu: Select FLUX =

J50-HS.

2.13 FU50 Steering Lever

For connection of the FU50 Steering Lever, see the FU50

manual.

2.14 TI51 Thruster Interface

The TI51 Thruster Interface is designed to provide control signal

for operating one thruster in an AP50 system by either on/off

solenoid, continuous control, or Sauer Danfoss PVEM valve.

Refer to separate manual for the TI51 Thruster Interface.

2.15 AD50 Analog Drive

The AD50 Analog Drive is designed to provide analog or

proportional control of a rudder in an AP50 system by either

continuous voltage, or Danfoss PVEM valve signal.

Refer to separate manual for the AD50 Analog Drive.

2.16 S9 Steering Lever

Mounting

Refer to Figure 2-29. For bulkhead mounting, use the 8 bushings

enclosed with the unit. These are placed two and two against

each other and the screws are put through them. Direct contact

between S9 and a steel bulkhead is then avoided and corrosion is

prevented. The cover plate can be turned 360 degrees for the

most convenient position of cable outlet. For panel mounting

use the two mounting brackets enclosed with the unit (Figure

2-30).

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 133 134

No comments

Simrad AP50 Installation Manual Page 42